gergroovy.blogg.se - Autocad mep 2020

The Insertion point Z-value of device shall be 0.The Z-value of Connectors should always be defined as 0.The elevation property of the device (not the insertion point) should be used to assign the 3D view to the correct elevation. For Preset Elevation, select a defined elevation.īecause devices have 2D views and many have 3D views assigned to them, the insertion point of devices should be specified as 0.Specify an elevation by doing one of the following:.

You can select either the insertion point of the view block that represents the device, or one of 9 other points on the device, such as Top Left or Middle Center.

For Justification, select the point on the device to use as the insertion point.

If you selected Distance around space or Quantity around space for Layout method, Align to objects is automatically set to Yes. As a result, you cannot specify a value for Justification on the Properties palette, or a value for Rotation on the command line. Note: If you select Yes for Align to objects, the software inserts the device using the insertion point of the underlying block and rotates it as needed to align it perpendicular to the object to which you snap. You can search, import ( ), and add a device ( ).

In the Styles Browser palette, select Object Type Device.

Because tools contain preconfigured properties for the objects they create, you might not need or be able to specify some of the device properties referenced in this procedure. If necessary, scroll to display the tool.

Open a device tool palette, and select a tool.

In the Electrical workspace, start the add command by doing one of the following:.

This ability means you can create circuits and connect them to devices at any time during the design process. When you add a device to your drawing, you can assign the device to a circuit, or you can leave the circuit unassigned until you know the circuit to use. You can also insert a device onto a wire, in which case the device breaks into the wire and creates 2 wires. You can place devices and then connect them with wires. After attaching a referenced drawing (xref) of the architectural plan to your drawing, typically you continue by placing devices and panels in the layout.